This a remix of Fish Skeleton Magnet by DDRBoxman (Thing:21951)

I thought it would be funny to make it into a fishing lure!

Used TinkerCAD to chop of the original STL into sections and added eyelets.

Probably the third thing I "made" after getting a 3D printer; so it's rather crude in design, so your slicer program may say it has errors in the drawing, but it still prints fine.

Assembled by tying the sections together with 30lb line; you can add extra sections if you want a longer. Also you can scale it up or down on your slicer program.

PLA tends to float, so either print with 20% infill and drill some small holes to let water in.

Or print 100% infill. Also adding a small sinker to the line before the lure helps keep below the water.

Also it works; because it makes so many vibrations underwater. Use triple hooks for best chances of hooking fish

Print Settings

Printer Brand:

Anet

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill:

Filament: Any PLA Any

Notes:

Category: Sport & Outdoors