Simple, no-support, strong single-print, corner quarter round tray 195x195mm with 4x M4 screw threads meant for bathrooms or any 90° corners.

My existing similar size glass tray broke and couldn't find similar anything close to print, hence sketched in Fusion 360.

Can be mounted either way, bottom flat upwards if you need slightly more space minus the mount points or top raised edge to prevent things from sliding off the tray.

Advisable to print in PET-G if you plan to mount it near hot shower. Not sure about PLA but mine in PET-G has been daily splashed for months with hot water from the heater. Printing should be done on the bottom flat-side and will fit a 220x220 printer bed.

Print Settings

Supports:

No

Resolution:

Infill:

20%

Filament:

Any PET-G

Category: Household