I needed a couple of funnels to use in the kitchen, and although there are many to choose from here on Thingiverse, I couldn't help but design my own. This design has ridges that keep it from sealing when used with a bottle or jar. It will always vent along the sides.

I printed it in three (3) sizes: Original, x 1.5, and x 2.0.

Print Settings

Printer Brand:

Printrbot

Printer:

Rafts:

No

Supports:

Resolution:

.25mm

Infill:

Notes:

I had to change the side walls from 3 layers to 2 layers, because the model wouldn't infill correctly on larger sizes (at least with the slicer I'm using). At 3-layer thick walls my slicer may as well have been set at 0% infill. At 2-layers thick, everything was fine and the infill worked properly.rnrnSome day when I can justify/afford getting Simplify3D !!! But not today.

Category: 3D Printing