I created this toggle switch housing to control the LED lights in my 3D printer's enclosure. It is intended to enclose a panel-mounted switch with a panel cutout of 28.5 mm x 13.5 mm and a depth of no more than 37.5 mm. It can be mounted using 2x 8mm screws.

There is a 5mm diameter hole on either side of the rear of the enclosure to accommodate the wires used to connect the switch to the circuit.

This model was created from scratch, but was inspired by Alberto Nidasio's light switch mount design.

No supports needed. Any material should work, but I used PETG. Just feed the wires into the holes in the enclosure, solder them to the switch and press-fit the switch into the front of the housing.