# Custom Case for Simple Servo Tester

This is a custom-designed enclosure specifically made for the Simple Servo Tester. I was really not a fan of the flimsy plastic film serving as the original case, so I 3D printed a solid, durable one myself!

---

## Hardware Required (BOM)

To assemble this, you will need:

* Servo Tester

* Screws: A few small screws are needed to secure the case. (Note: I honestly don't know the exact screw spec/size, sorry! 😂 Just grab a few small ones from your spare parts bin, or you can just snap-fit/glue it together if needed.)

---

## Print Settings

* Material: PETG or PLA

* Layer Height: 0.2mm

* Infill: 30%

* Supports: No supports needed

* Perimeters: 3 walls

---

## Assembly Notes

* Crucial Step: Before putting the board into the case, make sure to remove the plastic knob cap from the potentiometer first. Once the board is seated, you can pop the knob back on from the outside.