The prints were produced using both PLA and PETG;I used "Tree" supports (Auto), specifically the "Thin Tree" type, starting from the build plate;The part is oriented upright with the closure side facing the build plate (be sure to clear any support material from the clip's teeth). The tree support branches passing through the anchor clamp are directed only upwards to support the internal bridge connecting the clip to the base of the sheath; therefore, they must not adhere to either side;

Layer height: 0.2;Perimeter layers: 3;Infill density: 35% Gyroid;

In This Version it has been thinked to collocate a magnet that fix the corkscrew in a permanent static position before to get it out.The Magnet measures 1 cm. x 2 cm. x 3 mm., while the caliper measures 9,7 mm. x 19.10 mm. x 2.57 mm. in any case, these will be no misunderstandings by purchasing the product in the photo on the Amazon channel. The glue used is a cyanoacrylate.