SnapHook is a clean, modern, interchangeable wall hook system designed for everyday use. The hidden mounting base installs with two screws, then the hook simply twists into place until it locks. When you're ready for a different attachment, just twist it off and swap it out.

This is the first attachment in the SnapHook system, with more interchangeable designs coming soon.

Print Settings

• Material: PLA

• Layer Height: 0.20 mm

• Infill: 20%+ recommended

• Supports: Hook only (base prints without supports)

Installation

Mount the base using two screws. Use drywall anchors if you're not mounting into a stud. The hook has been tested to hold up to 10 lbs.

If you print one, I'd love to see your make and hear your feedback!