This 3D model was created with the help of AI 🤖.
I separated the otter into parts (body, eyes, nose and belly).

A little Otter for someone special, or just for yourself!

I decided to give the outer fur (brown) a knitted texture while keeping the inner parts (beige) smooth for a nice contrast.

Otters are naturally adorable animals, and I already have a few more ideas in mind that I might upload in the future.

Print tip: If you don't have brims enabled for small parts like the eyes and nose, I recommend turning them on. These pieces can be a little tricky to print and the extra adhesion helps a lot.

Hope you like it, and happy printing!

General Print Settings

• Nozzle: 0.4 mm

• Layer Height: 0.16 mm (Bambu High Quality profile)

• Wall Loops / Perimeters: 2

• Detect Thin Walls: Enabled

• Infill: 15% Gyroid

• Material: PLA+

Support Settings

• Support Type: Tree Support

• Support Angle: 25°

• Support Placement: On build plate only

• Brim active

General Printing Information
Tested on a Bambu Lab P1S
Material: eSun PLA+ Beige  (belly)
Material: eSun PLA+ Black (eyes, nose)
Material: eSun PLA+ Brown (body)