This is a photogrammetry scan that I did of a Mosasaurus tooth. 

This is a super wasy For best results, follow these print settings:

• The footprint is smaller than preferred, so have either a raft or a brim to prevent the print from falling over

• Print with a much smaller layer height. I did 0.08mm.

If you do not feel confident with printing without supports, you can paint tree supports around the base, or, alternatively, orient the model this way:

Mosasaurus Fun Facts:

Source: [https://en.wikipedia.org/wiki/Mosasaurus#/media/File:Mosasaurus_hoffmannii_-_skeleton.jpg](https://en.wikipedia.org/wiki/Mosasaurus#/media/File:Mosasaurus_hoffmannii_-_skeleton.jpg)

• The name means, "Lizard of the Meuse River"

• The first Mosasaurus fossil was discovered in the mid 1700s

• The largest specimens were thought to grow as large as 39ft (12m)

• Mosasaurus likely preyed on shark, turtles, bony fish, birds, cephalopods, and marine reptiles

Source: [https://en.wikipedia.org/wiki/File:Mosasaurus.jpg](https://en.wikipedia.org/wiki/File:Mosasaurus.jpg)