Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

This bookmark features a striking silhouette of a gnarled, dark tree trunk, intricately cut to reveal the book page beneath. The canopy bursts with vibrant, multi-layered green foliage.

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Brown Transmission Distance: 2.4 (or Orange)
    PLA BambuLab Basic Bambu Green  Transmission Distance: 4
    PLA BambuLab Basic Yellow  Transmission Distance: 6
This print uses 4 unique filaments

 Swap Instructions:
    Start with Black
    At layer (1.04mm) swap to Brown (or Orange)
    At layer (1.2mm) swap to Bambu Green
    At layer (1.52mm) swap to Yellow for the rest. 

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - [https://makerworld.com/en/@3djd/collections](https://makerworld.com/en/@3djd/collections)