simple to print wind vane with push fit & glued in place n-s-e-w markers

choice of 4 arrow pointers ( 3 print in place with supports needed the other 1 is in 3 pieces and glues together with lower supports where bearing goes

uses 2 x 608 bearings in the arrow of your choice

printed in Petg or any filament you choose,

i only have ad5m so all one colour print but the nsew letter could be done different colour on  a multicolour machine

the 3 support parts will need pausing at correct level for m8 nuts to be inserted 

mounted on m8 studding to you required length 

washers go either side of the arrow

do not overtighten the assembly on the m8 stud

also i put m8 nut on bottom of the assembled unit for extra security