DISCLAIMER!:

this is the prototype version and does not have a large selection of parts, the v2 will have a payload fairing, upper stage and payload section.

this is a 99 percent 3d printed model rocket that is inspired by Kerbal space program, it can use:

.any 12+ inch parachute

.b6.6 to c6.5 estes model rocketry engines

.a standard estes (rod type) launch stand 

REQUIREMENTS:

.print in PLA because it does not shatter like PETG

.must have 3 walls and gyroid infill

 .print the fin can with 30% infill

if there are any problems or suggestions, leave a comment and I will read them every week

ALSO: in the print files there is a part for helping to glue up the body tubes.