About/Origins

I created this model because, I like the aesthetics of the vintage push button light switches that I saw in an old building from the early 20th century. I wanted a simple way to convert my rocker switch to a push button switch, so I created this. It it does not use too much material, the whole thing totals in at about 21 grams. I created it so that no adheasives/drilling are needed to install it, instead it attatches to your existing light switch by using the screws already on the rocker switch.

Assembly

To build this, you first need to print one plate and 2 buttons, after printing them, place the buttons onto the plate so the small end is facing to the outer side. Next, remove the screws from your lightswitch and keep them nearby. Align the plate to the rocker switch, so that the theads on the switch and the screw holes on the plate line up. Put the screws from the lightswitch through the screw holes on the plate, and tighten them. Once done, you will have a cool looking and very satisfying light switch.