Bracket to hold a proper fused switched power connector to Rolohaun's Rook MK2 DIY printer.

I used this connector: [https://www.amazon.com/dp/B0FZKQ6NSN](https://www.amazon.com/dp/B0FZKQ6NSN)

Screw sets need to be on the short edges of the power connector or the bracket is too tall to fit under the frame. Opening is 27.9x47.5mm.

Put 2 inserts into the rear facing extra hole on on side of the bottom frame piece and 2 inserts into the bracket to hold the socket in.

Also need:

• M3x5x4 heat set inserts - 2 for the frame, 2 for the power switch

• M3 screws -  2 for the frame, 2 for the power switch