This is a remix of Jubaz's micro:bit V1 case, specifically updated to provide full compatibility with the micro:bit V2. While the V1 and V2 share the same footprint, the V2's internal component shifts and new hardware features required a physical redesign for a proper fit and functionality.

Key Improvements:

• V2 Component Alignment: Adjusted the internal back supports to clear the changed component layout on the V2 board, ensuring a flush fit without putting pressure on the hardware.

• Audio Support: Added a dedicated cutout/clearance for the built-in V2 speaker.

• Sensor Access: Widened the front opening to allow unobstructed access to the touch-sensitive logo and the built-in microphone.

Printing Recommendations

• Material: PETG (recommended for the snap-fit tabs) or PLA.

• Layer Height: 0.2 mm 

• Infill: 15-20% Rectlinear (or Grid).

• Top/Bottom Layers: 4

• Supports: None required (designed for print-in-place).