This was a joke valentines gift for my dear friend with very nice butt (we both know it and this is a tribute to it). It looks like a heart BUT sits like a butt ;)

It was a last minute idea before I went to see her before Valentine's day and it was very funny.

I printed it with supports since it is printed staying on the two contact points. The stand is inserted from behind as press-fit (might be quite tight). I printed original size as first, but also printed bigger one and actually I gifted both since they made a nice couple.

Print settings

• nothing special
• supports or raft needed

Assembly

Push the stand from the back to the oriented hole in the heartbutt. The angled flat side of the stand should stick out in just the angle to be in full contact with the table or shelf. It can be quite tight to press it in. Don't be afraid to use power to get it into place. No glue needed.