Simple box for a pin vice and some drill bits. The bottom of each draw is curved slightly to (hopefully) make sliding the bits out easier. 

The tolerances are a little loose so I have a dab of blue-tac on the end of the inner portion to keep it in the 'lid' but the aim is to keep things together rather than be an super tough box.

Dimensions are:

• drill 90mm x 17mm (outer diameter) or 11mm (body diameter) with the tail section 11mm and the head 21mm long

• main drill bit drawer 90 mm long x 8mm deep

• medium drill bit drawer 50mm long x 5mm deep

• small drill bit drawer 38mm long x 5mm deep

Printed using Prusa PLA natural with a 0.4mm nozzle and 0.2mm layer height with support for the overhangs on the drawer & main box