Easy to print picture that shows surprise under light!

Printing instructions - use white filament!

• Use either 100% infill or many walls/perimeters
• Recommended layer height is 0.12 however if you want the most detailed print, go lower. Maximum layer height in my opinion is 0.2
• Use BRIM and print in given position
• No supports

In case you want to do your own lithophanes, here is how I did it 

1. Find suitable picture - good contrast; usually simpler picture prints better than one with lots of details
2. optional - use photoshop or any editing software (like the one in your phone gallery) and boost contrast, play with vibrance, saturation and sharpness.

     3. Upload your image to 3dp.rocks - on top click “Images” and upload yours then move to             “Model” where you choose the type (curved, flat..) and hit refresh.

     4. All there is left to do is change “Settings” - I use the one below this paragraph. The most            important is “Maximum size (MM)”, that changes the model size. After any change you              need to click REFRESH in the model settings.

      5. Download your STL file and put it into slicer

      6. Enjoy!

Note: This is not the final version of this page, I will keep updating it - mainly to make it better looking and readable. If you do not understand something, please ask in comments so I can update it :)

In case you have any requests, feel free to send me a message and I will try to help you out!