Yeah... cause you lose em all the time...

Holds tight and easy to grip with your nails... cause you know you are wearing nails.

Print it with TPU at 0.1 layer height.

NOTE: The hole is small right after the print, so work the earring in it a few times to get a good fit.

Tips for Printing TPU

• Slow it Down: Print speed should be slow, like 60mm/s

• Big Hole: Print Nozzle should be a little bigger to avoid clogs, try 0.6mm

• Ditch the Friction: TPU needs low friction to print or it binds and streteches, giving an uneven diameter to your filament as it feeds. To resolve this, feed the filament directly into your print head, avoiding the bowden tube. Additionally, try using a low friction spool holder (like this) and/or an overhead spool holder (like this) if possible.

P.S. it's bonkers that this was not already on here...