A tiny and cute Elephant for your desk. It is very small (approx. 20mm) and prints extremely fast. Perfect for using up those last bits of filament!

The tail is very thin and might fall off if support is not removed carefully. Plus side is that it is still cute without a tail. 

Features:

• Ultra Lightweight: Uses less than 1 gram of filament.

• Fast Print: Ready in under 15 minutes.

• Great Gift: Perfect as a small "desk buddy" or a fun surprise for friends.

Print Settings:

• Layer Height: 0.12mm (recommended for the smoothest look)

• Walls: 2

• Infill: 15% Gyroid

• Material: PLA

Check out my other mini desk buddies in this collection: [https://www.printables.com/@SimplySolid_4346362/collections/3141769](https://www.printables.com/@SimplySolid_4346362/collections/3141769)

💼 Sell my physical prints? Get your Commercial License on Patreon 
❤ Support my work (€2): Get voting power & sneak peeks on Patreon 
☕ One-time tip? Sponsor 100g ($2) of filament on Ko-fi