Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
I love the Stackable Containers from Dennisbun, so kudos to him for working out those dove tail interfaces!
I found it difficult to get small parts back out of the original bins so slopped the front face.
Print Settings
Set extrusion width to 0.65 mm
Layer height 0.2 mm (might want to try higher height)
Vase mode
Low wall speed
Bottom layers 3 (at least)
Top layers 0
The above settings were copied directly from Dennisbun's original Thing.
Category: Organization
8
Me gusta
37
Descargas
Categoría
Office
Etiquetas
thingiverse
Licencia
Creative Commons — Attribution
Archivos (1)
Stackable_Container_-_v5_Sloped_Front_158696.stl
365 KB