Printing: I printed it using Prusament PETG using the 0.25 Speed profile.  Recommend increasing perimeters to 3 and using 25% infill.

Assembly: Use M3x4.0mm heat set inserts with an OD of 4.6mm.  I used these ones here: [https://www.amazon.com/dp/B08T7M2H4S?th=1](https://www.amazon.com/dp/B08T7M2H4S?th=1)

Mounting: This bracket has additional screw holes to help hold it in place when mounting it to Maurício Pessoa's 6 inch rack mount system when mounting it in the top or bottom slot where there are no top or bottom screw holes.

Usage: LabStack modules will mount using M3 screws of at least 8mm in length to mount the modules to the bracket.

Designed in FreeCad.  Please use the attached .FCStd file if you wish to modify it for your own purposes.

Compatible with this 6 inch rack mount system: