Since many like the other flower design and some asked if I could also make different ones, I decided to design these also from scratch to be nicely printable and don't need supports (I mean these are flowers, they should really be nice to the environment).

I'm always happy when you share your makes :).

I tested the designs with multiple materials to make sure most of you can print it easily.

It's an alternative version of the large brick flower I made earlier: [https://www.printables.com/model/158019-large-brick-flower](https://www.printables.com/model/158019-large-brick-flower) 

The parts are interchangeable, so you can use these blossoms on the other stem and vice versa.

There's a small difference in the length of the studs that hold the blossoms, that is caused by making it more compatible (regarding the height) to my printer.

Print Settings

Printer Brand:

Ultimaker

Printer: 

Ultimaker 3

Rafts:

No

Supports: 

No

Resolution:

0.2mm

Infill: 

20%

Filament: Formfutura ABS multiple

Notes:

I recommend using a brim, especially on the stem, because the surface area is quite small and it's relatively tall. If your printer has a moving bed in the x- and/or y-direction I recommend to use some slower than usual print and travel speeds to reduce the stress on that small contact area when the print is getting taller.
If you print a smaller version (like 50% of the original files) I recommend to print multiple stems at once, that can reduce cooling issues and provide a nicer surface finish.

All parts can be printed without supports, I tested it with PLA, ABS and Nylon (not for the stem, since I didn't have green nylon on hand).

Category: Sculptures