Stackable dice containers for your dice and miniatures. Sized for the largest dice I've found (gemstone dice that are larger than a typical 7-set). Feel free to reduce size in the customizer.

The figure storage container is a bit taller to accommodate standard 25mm based figures with a touch of room to spare. If your figure cannot lay flat with z clearance of less than 26mm, you can easily adjust this in the customizer.

The connectors fit very snugly with a 0.1mm clearance on all sides. If your printer is not dimensionally accurate you may need to increase this gap. The first time you twist two pieces apart, it will likely require some force. The groove will wear in after a few tries and hold a good friction fit.

These are the magnets I glue in to the holes, six per box, three per lid: [https://a.co/d/0iMHo2W](https://a.co/d/0iMHo2W)

Update - Added some customizer hints based on feedback and added the ability to use custom text or logos (not provided) on the lid.

Update 2 - Added a rounded design with grips to make opening and closing easier.

Update 3 - Updated .scad file with latest improvements. Added helical grip option.

Update 4 - Added new .scad with improved helical grip and holes for magnets in place of three tabs.  The intended magnet size is 6mm diameter x 2mm height.  The .scad file can of course be used to customize this.

Update 5 - Created “Jumbo” version for 25mm dice.  I acquired a set that would not fit the original models.

Update 6 - Latest models fit my largest dice while being smaller than the previous “Jumbo” boxes.  I'm including a new figure box sized to fit.  The latest release is not compatible with older files.  Added extra grip with fuzzy skin in the slicer, you can disable this if you do not like it.  There is a new pad model that consists of the 7 hexagons sized to be glued inside the pockets.  I print these in TPU.  I've also decided to release the lid model featuring the D&D logo after reviewing WotC's Fan Content Policy found here.  To wit:

The dice box lid featuring the D&D logo is unofficial Fan Content permitted under the Fan Content Policy. Not approved/endorsed by Wizards. Portions of the materials used are property of Wizards of the Coast. ©Wizards of the Coast LLC.

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

15

Filament: Prusament PLA Galaxy Black

Notes:

I recommend "Archimedian Chords" for top and bottom layer fill patterns.