Estás en 3DFinder

Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.

Modelo 3D HDZero Echo patch mount for HDZero Goggles por Alex Veden en Printables

Descripción

There are two different mount versions for printing in TPU and hard plastics (ABS/PETG/PLA etc.). The difference is the cutout on one side of the mount.

You can not fit TPU version if it is made of hard plastic because of goggle's geometry.

Default antenna mount angle is 10 degrees, but there are versions with 0-5-10-15 degrees available.
There is a global variable in SW file where you can customize the angle to you liking.

I do not own the goggles 3d model it was taken from the open sources, all rights belong to HDZero.

Printables

HDZero Echo patch mount for HDZero Goggles

Alex Veden

Publicado el 31 de ene. de 2026

Me gusta

Descargas

Categoría RC & Robotics

Etiquetas

patch echo antenna antennamount hdzero hdzerogoggles echopatch

Licencia Creative Commons — Attribution

Archivos (12)

hdzero_echo_patch_mount_hard_0.step 245.8 KB

hdzero_echo_patch_mount_hard_5.step 245.6 KB

hdzero_echo_patch_mount_hard_10.step 241 KB

hdzero_echo_patch_mount_hard_15.step 243.7 KB

hdzero_echo_patch_mount_tpu_0.step 242 KB

hdzero_echo_patch_mount_tpu_5.step 241.8 KB

hdzero_echo_patch_mount_tpu_10.step 237.1 KB

hdzero_echo_patch_mount_tpu_15.step 238.5 KB

hdzero_echo_patch_mount_tpu_20.step 247.2 KB

hdzero_echo_patch_mount_tpu_25.step 247.2 KB

hdzero_echo_patch_mount_tpu_30.step 250.4 KB

hdzero_echo_patch_mount.sldprt 6.2 MB

Ver en Printables

¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.

Crear cuenta

Comparar ahora