I have a snowblower that's had a broken pull handle for years.  Yeah, I'm TOTALLY on top of that.  Cup finally filled to the brim so I sat down, designed this, printed it out (warmed up a bit) and then went back out and replaced the broken on. Worked GREAT!!  Works with gloves so no problems there.  

I designed pinholes to push through glued solid filament to align and help keeping the parts from swiveling.  OK, I didn't really get it out the same day, I used some E7000 glue, clamped them down and it was ready the next day.   Used it several times since installing, works great!

I used PETG, 3 shells.  The bulk handle part was at 15% but I used 50% for the handle sides down to the cord connector.  Print twice, glue, clamp, done!