Hello everyone! This is a 3D printed shell designed to work with the X-Shot Excel Ejector Shell Blaster.  I've been having tons of fun with this blaster, and I have several ideas for fun parts to make for it.  The first and most obvious part was to make a 3D printable shell to either supplement or replace the four shells the blaster comes with.  So, that's what I set my set out to make first, and here are the results!

I've uploaded two different shells: a version that has a dart stop in the rear of the shell, and a version that is open in the rear of the shell.  While it's easier to load full length darts into the shells with the dart stop, loading short darts was annoying due to having to push them all the way back through the tube. So, I made a version of the shell with an open back to allow for short darts to be rear loaded. I tried to find a nice balance between power and dart fit for the internal diameter, but if you'd prefer a tighter dart fit, I've included STEP and F3D files for anyone who wants to make their own edits!

Neither shell design requires support material, and both are fully compatible with the stock blaster. I hope this part helps you enjoy this blaster as much as I have!

EDIT: A shell with a tighter dart fit has been added for use with used darts.

EDIT #2: I noticed that the shells did not fit well into the shell holder that came with the Ejector, so all versions of the shells have been updated with a slightly larger outer diameter. Additionally, after some further testing, the Original versions of the shells have been changed to slightly tighter dart fit that holds the darts better, but is still less tight than the Tight versions of the shells.