A hex ruler for use with 1" hex grids (where the size is flat-to-flat). One side is for measuring the in the repeating direction (i.e. where the points are up/down, each gap is 1") the other for the alternating direction (i.e. where you go through an edge then the centre, where each gap is 1"/sin(60) )

I mostly made this to speed up drawing maps for Lancer on my dry-wipe map.

Settings

• PLA

• 0.6mm nozzle, 0.3mm layer height

I'd recommend using something like sharpie to flood-fill the numbers then wipe the excess off the top to make them more readable.