Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
These are mainly for use with the lithophanes available on Gadunky.com(but work on anything that will fit in them). They hold the lithophane at an 80° angle for best viewing(the flat section with the curve should be facing the back).
Print with 100% infill in whatever material and colour you like(tested with PLA, PETG and ABS). A layer height of 0.2mm is a good balance between quality and print time on these.
The height of the lithophane must also be considered when using a stand. These have been designed to comfortably hold a lithophane with a height 1.75x the length of the stand. So the 180mm version should hold a lithophane with a height of 315mm(180mm+75%) without falling over. In practice it will hold a much taller lithophane than this, but we only recommend up to 1.75x the length.
If you need a particular size just comment and I'll add them. I need to know the length of the lithophane, thickness and how tall it will be.
File name breakdown:-
LithoStand-Gadunky.com-v3b-3.2mm-200mm.stl
v3b: Version 3b of the stand design.
3.2mm: For use with 3.2mm thick lithophanes.
200mm: For use with 200mm in length (or smaller) lithophanes.
All files follow this naming format.
.
Print instructions
0.2mm layer height is perfectly fine for these.
100% infill,
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta