Case for the NUC7I5DN Intel NUC motherboard, which along 8G of RAM and 64G SSD i could source for like 25$. Sadly they didn't come with a case, so made my own.

Notes:

• Feet required, air intake is on the bottom, so we could have some airflow over the RAM and VRM.

• Intake and exhaust guards are meant to be printed with 0 top, bottom and wall loops, just ~20% infill

• Feet ware made from TPU

• Case is meant to be printed with some kind of semi-transparent material, like PET-G, so front LED would be visible. 

• If You use full opaque filament, well - drill a hole

• Bottom cover & mainboard standoff holes should contain 4x3x3mm threaded inserts

• Front & back panel mounting holes are meant to be tapped with M3 tap. But wood screws should be also fine here

• It should fit any UCFF main board, but most likely You will need to make front & rear panels for it

• Use internal WiFi antennas