These are some simple Snowflake Ornaments. This is a set of three. There are other snowflake sets, go to my account to check them out. They are 3mm thick, so nice and sturdy, but not too thick for a snowflake. They are numerated, go on the second picture to see the numbers. They all have a hole at the top so you can easily pull a thread through (how big the hole is depends on the size of the snowflake, mine work just fine)

Print Settings:

You can scale them to your desired size, I scaled mine so that they are all around 10 by 10 centimeters (130% or 140% depending on the snowflake in Bambu Slicer).

Mine were printed in PLA, but PETG should work just fine.

I absolutely recommend using a brim so that adhesion issues can be prevented.

The print time varies depending on size, but if you print them one at a time, they shouldn't take long. I printed 3 at a time and they took from 1 - 1.5 hours. 

I attached the Bambu gcode file that I used for my snowflakes.

Have fun printing and feel free to post your makes! Merry Christmas!

Note: The original artwork is not mine. I only created the 3D printable file.