This is a hard case for traveling (or storing) with your darts. Most cases require you to remove the flights but not this one. There are also viewports so you can see which darts are inside without having to remove the lid. No supports required. 8% infill, 2 perimeters is enough. The case is meant for steel tip darts measuring a full length (point, barrel, shaft, and flight) of 156mm but any length smaller will work.

Update 12-28-25 : Added an accessory space (for spare shafts, o-rings, etc.)

Enlarged the model slightly to accommodate wider flights

Enlarged flight space (38 mm wide flights will now fit)

See my other models here (some more dart accessories models, too)

[https://www.printables.com/@MichaelBuch_2353278](https://www.printables.com/@MichaelBuch_2353278)