Check out the new version with joysticks: [https://www.prusaprinters.org/prints/149804-gamepi-2](https://www.prusaprinters.org/prints/149804-gamepi-2)

This a simple sleek shell to create a raspberry pi based portable game station.

It was designed around a 5" Elecrow Display and a Raspberry Pi 3.

I've added two versions of the shell:

1st: Front and back cover are made from one part (fits fine on a 21x21cm bed)

2nd: Front and back cover are split into 3 parts each (for smaller printers)

For the build shown in the pictures I've use the following parts:

• 5" Display ([https://www.amazon.de/gp/product/B013JECYF2](https://www.amazon.de/gp/product/B013JECYF2))
• Raspberry Pi 3 ([https://www.amazon.de/dp/B01CD5VC92](https://www.amazon.de/dp/B01CD5VC92))
• microSD Card 64GB ([https://www.amazon.de/gp/product/B073SB2L3C](https://www.amazon.de/gp/product/B073SB2L3C))
• Power (Electronics/Batteries) ([https://www.amazon.de/gp/product/B00XTVOAQM](https://www.amazon.de/gp/product/B00XTVOAQM))
• Stereo Amp 2x1,5W ([https://www.ebay.de/itm/271513588858](https://www.ebay.de/itm/271513588858))
• Soft Tactile Switches ([https://www.amazon.de/gp/product/B01JD3H5RK](https://www.amazon.de/gp/product/B01JD3H5RK))
• Buttons from an old Controller
• 3,5mm switched Stereo Jack
• small 1,5W Speakers from an old notebook
• other small parts and cables

You can leave a tip (button left) if you like my stuff.