This was designed to watch the chipmunks that visit our back patio in the morning. I looked to see if there was specifically a “Chipmunk Feeder” available and it appears squirrel feeders will get visited by chipmunks but nothing was designed for chipmunks that was 3D printable.

I took the volume and size of the hole into design consideration. There are (2) versions, a single entry/exit and double entry/exit It is designed to be fastened to a post with screws (2 - 4: #8 - counter sink, coarse thread screws). In reality it could be installed a number of ways, I will adjust the model for special requests…i.e. round pole, 1x1, etc…just send me a message,

This is a print in place model that does not require supports. 

*After I designed this I realized it looked very familiar to my RV/Caravan Veggie storage device. 

Designed in Solidworks