The Nintendo Switch 2 is just too wide for my EDC bag, but I realized if I could just carry the joycons seperate from the main body, then it wouldn't be too much of a problem.

The “tablet” unit obviously can just be put in any sort of slip case for a similar sized tablet, but I modeled a box for it as well.

The “boxes” do NOT lock together and are held together by friction. 2 versions of the top halves are provided depending on your printer accuracy and tightness preference.

After Printing

• Use 2mm thick foam tape on ALL inside surfaces of both halves the tablet's box (including the bottom) to prevent the tablet from scratching against the case.
• Use 2mm thick foam tape on the inside side edges of the bottom half of the joycon box to stablize them from shaking around.
• Use the pictures as a guide on where to put the foam tape.