This is the feed point and wire clips for a wire Delta Loop Amateur Radio antenna. I use mini-banana receptors on the ends of the inductor and zip-tie them to the bottom of the “T” crosses. I also use heat shrink to protect the BNC and inductor.

I printed with PLA at the Draft setting in Cura, though you could probably use PETG if this will be used outside for a semi-permanent or permanent installation. This is my first creation, so updates will be made going forward.

Usage:  The feed point can be hung in any configuration using the holes provided or attaching cordage. The wire will connect in a loop, and the wire clips are used to tie it out into the loop form. I've had great performance hoisting the middle of the loop (apex) up high, tying 2 legs off to make a triangle and putting the feed point in the middle of the bottom flat.