Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Another great design by Stewart Coffin. Wood copies are beautiful but very expensive. Six pieces, all different, assemble in an unexpected way into a cube. This puzzle can be tricky to take apart if you don't know the secret. But putting it together is the real challenge.
The assembled puzzle is a 6 cm cube. The small cube in the photos was ordered from Shapeways many years ago and is only 3.2 cm.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.20 mm
Infill:
15%
Filament: Hatchback PLA various
Notes:
Print each file containing two pieces in a different color. No supports are needed. Pieces on opposite faces are the same color. If you are paying careful attention, this makes the puzzle slightly easier.
These pieces work well with a very low offset (10 microns), zero offset works too. They were created using a BurrTools export with the following parameters:
Unit size=15.0
Bevel=0.5
Offset=0.01
Thickness=0.0
Tubes size=0.0
Leave inside grooves=off
Leave outside grooved=off
Remove grooves in void=on
This puzzle is included in the BurrTools examples.
Category: Puzzles
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta