I wasn't able to find any table numbers that I liked, so I designed some of my own. Fortunately in my case, we only had 9 tables. For the font, I used BKANT.

I printed with the following:

• Numbers with Prusament PLA Galaxy Silver

• Base plates and pegs with Atomic Filament Deep Black PLA

I also enabled ironing which I don't think was worth it (caused some odd artifacts in my case).

The pegs are super glued into the numbers and friction fit into the base. NOTE, there are special base plates for 7 and 9 due to the peg locations being offset. The 7 and 9 base plates are labeled on the bottom.

The dimensions are:

• Numbers - 5" x 1" (width depends); OR 127mm x 25.4mm

• Base Plates - 140mm x 60mm x 10mm

• Pegs - 11.9mm x 11.9mm x 13.2mm (11.9 for clearance)