A simple photo frame designed to use minimal filament and print relatively quickly. Multiple size options from 3.5x5 to 5x7 (still figuring out how to fit 8x10 on a mk3). For either wall mounting or with a stand to place it on a desk or table. There is a slot on one side to insert a photo; be careful not to get fingerprints on the picture when seating it, I usually just tap the bottom of the frame until it seats fully.

I suggest printing with a brim, 5mm should be plenty though the 5x7 wall version may need some extra support to stop it from leaning over. 

10-15% support cubic infill, 2 perimeters and reduce fan speed to 40-50%.

Edit: updated 5x7 to improve print reliability. The small support “fin” should be easy to remove with a utility knife or a pair of scissors and a file (or just break it off.)