LCD supports made for mounting the LCD outside of an enclosure.

It uses snap-fits so the LCD can easily be removed if wanted.

It has been made so the mounting plate can be placed both horisontal and vertical.

There is a drill guide included that makes it easy to mark out screw holes and give a few mm distance to a wall if mounted on a plate. It has a small notch representing the center of the guide as well.

Once the supports has been assembled to the LCD they sit really nice to the plates and it snaps right into position.

Drill guide was printed in PLA and other parts in PETG.

I printed the mounting plates as pictured without brim or support, a little bit cleaning up was necessary but adhesion to textured plate good enough.