This was created to add to my Clock 45 from Brian Law's Wooden Clocks. It needed a winder so here you go.  The square key hole on the winder is 4.6mm wide and 11.75mm deep.

Total print time is about 2:30 

Filament: PLA

A raft is recommended as these are pretty small.

Supports:

You should not need supports for the Barrel and Knob if printed vertically and you use a raft, but the Arm will need supports if you do not print it on it's side.

Hardware:

2x - M3x10 Screws

When fitting the knob to the arm, leave it a bit loose so the knob will spin.

This model is open and available to the public on TinkerCad here: [https://www.tinkercad.com/things/9CYt2KKoTQs-clock-winder-v1-0](https://www.tinkercad.com/things/9CYt2KKoTQs-clock-winder-v1-0)

Happy Printing!

You can help
To help cover the expenses of printing prototypes for the models I share, please consider a donation by purchasing an item from my Amazon wishlist here

Please leave a comment and let me know how you like this model. 

Also, if you like this model, check out my other models over here:

[https://www.printables.com/social/130916-hendersons-handcrafts/models](https://www.printables.com/social/130916-hendersons-handcrafts/models)

Below are just few of my other models