Você está no 3DFinder

Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.

Modelo 3D Halloween Vampire Teeth por EngGraph no Printables

Descrição

Vampire Teeth – 3D-Printed Halloween Accessory

Perfect for your vampire costume: these lightweight, reusable vampire teeth are 3D-printed and, with PLA Glow, deliver a spooky glow-in-the-dark effect. Easy to print, quick to assemble, and comfortable to wear—ideal for photos, parties, and cosplay. For best results, charge under light before use.

Use & Fitting – Vampire Teeth

You’ll need:

Steps

Done—your custom-fitted Vampire Teeth are ready!

Tip: Too loose or too tight? Reheat the PolyMorph and adjust. Store dry after use.

Printables

Halloween Vampire Teeth

EngGraph

Publicado em 4 de out de 2025

42

Curtidas

265

Downloads

Categoria Cosplay & Costumes in general

1	Print the model Print the Vampire Teeth as specified (PLA Glow recommended).
2	Heat water and fill the glass Heat water to just below boiling (about 60–70 °C is sufficient for PolyMorph). Carefully pour the hot water into the glass.
3	Add granules Add one teaspoon of PolyMorph granules to the glass.
4	Wait until transparent Wait briefly until the pellets turn clear/translucent and clump together.
5	Remove the material Use the spoon to take out the softened mass (caution—hot!).
6	Pre-shape & press in Quickly form a small sausage/wedge and press it into the 3D-printed model so the socket is filled.
7	Fit to your teeth Place the Vampire Teeth onto your teeth and bite down gently so the material molds to your bite (don’t clamp hard). Let it harden Wait a few minutes until the material cools and hardens completely.
8	Remove & finish Take off the Vampire Teeth. Carefully trim or deburr any excess hardened plastic with a craft knife.