• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
• At profile is model size is 200 x 200 
• You can use raw .stl file 150x150 also.
• Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. 
• You may print at higher layer heights below the Min Depth of 0.48mm The Max Depth is .2.16mm and the Actual Depth is 2.16mm

It is possible to print without material by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.

PLA Anycubic Black Transmission Distance: 0.3 
PLA BambuLab Basic Blue Gray Transmission Distance: 3 
PLA Elegoo + Gray Transmission Distance: 3 
PLA Elegoo Basic White Transmission Distance: 7 
This print uses 4 unique filaments 
Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Gray
At layer #16 (1.36mm) swap to White for the rest.