A stand to display or work on your mini-plank or similar drone, with “Lift” and ladder embellishments on the end faces. The stand uses a sturdy and low-profile design that supports the wings of a mini-plank drone while providing clearance for a 4x4x3 or 4x4x2 push prop that can remain mounted while on the stand.

Print Settings

Print the stand as is, without supports. You may get a warning “Floating bridge anchors, consider enabling supports,” but I safely ignored this warning and did NOT enable supports.

Slicer: AnkerMake Studio

Printer: AnkerMake M5C 

Filament: PLA (Polymaker Galaxy PLA)

Nozzle: 0.4mm 

Layer height: 0.2mm

Infill: 15% Grid

Time: 5h 14m 

Consumables: 41.03m 122.37g filament

Size: 200 x 162 x 54 mm (fits on a 220 x 220 print bed)

Tips

I added strips of self-adhesive closed-cell foam on the tops of the two supports to provide a more stable and custom fit.