Big wall clock! I used to print it using PLA made by Reflow (brand doesn't exist anymore), but can be printed using any other brand of filament.

Fits standard clock mechanisms.

I used to print them with a part of the back open to slightly decrease the amount of filament and to show how a 3d print looks from the inside.

Suggested parameters:

• print face up (so that the clock face is facing up)
• if you want to have separate colours like in the photos, change the filament after the last full layer
• you might need to adjust clock hands to match your mechanism and your printer

Since it has 24cm diameter, make sure you have big enough 3d printer :)

3mf model created with OrcaSlicer, might not work with other slicers