This is a snowflake adorned translucent cube intended to fit over a standard LED nightlight. The MMU 2 color print designed to print flat and then fold into a self locking cube. This print, and a previous redstone lamp nightlight, was created in OnShape.

Print instructions

Best to use included 3mf
.4mm extruder
Print 2 colors.
Extruder 1 = Clear
Extruder 2 = Opaque (Black, Blue, Red, White...)
number at end of .stl filename indicates extruder!
.2mm quality setings
general:
Horizontal shells: top, bottom = 1
Fill Density = 100%
Fill Pattern = Hilbert Curve
Top fill pattern = Rectilinear
Bottom fill pattern = Rectilinear

Special:
for "Nightlite - Back_Clips1.stl"
set Infil:
Density = 15%
Pattern = Gyroid

set Layers and Perimeters:
Bottom = 3
Perimeters = 2
Top = 3

for "Nightlite - insert2.stl"
set Layers and Perimeters:
Bottom = 1
Perimeters = 1
Top = 1

After print, cool and release from bed. leave on bed, set bed temp to 65deg (for PLA). Once to temp, carefully fold side panels perpendicular to bed. fold up bottom (with hole) to engage groves on side panels. fold (roll) assembly over last 2 panels, but dont crush the clips. remove from bed and cool final panel slightly before engaging clips.