A printable lampshade with included holder. I recommend to print it in a heat and UV resistant material so it holds up for a while and dont release harmful gases from the hot bulb. 

Assembly

Slide the holder down the lampshade until it snaps in place. It was quite tight for me so you can scale the holder down a bit if you experiences difficulties. 

Print settings

No supports needed. I used PETG with 4 walls, 30% gyroid infill and 0,15mm layer height on a 0.4 nozzle. 

Could be possible to print it in vase mode, if you try it out, please upload your make! I would love to do it myself on a 1mm nozzle and see the nice layer lines, but i dont have one at the moment