Description

An easy-to-print, foldable, multi-purpose hook for hanging items. 

• The design is simple and requires no support.

You will need approximately 16g to 25g of filament.

• LIGHT version 16g of filament

STRONG version - full perimeter 25g filament

• Dimensions: folded state 76,2 x 53,3 x 10 mm  (3 x 2.1 x 0.39 in ) 

                                  unfolded approximately twice as much.

Tested with PLA or PETG filament.

NOTE: I wanted to minimize gaps so that the hooks would not have too much space around them at the attachment point and would not deviate too much from the axis. At the same time, I wanted them to be printed from a single piece without gluing or screws. 

Therefore, try to follow the procedure below.

After printing, allow the hook to cool sufficiently. 

Then adjust it for further use by turning it slightly.