Super easy to print using general standard setting for PLA, no supports or brim needed 100% infill. middle Finger switchblade. 


To assemble:

1. Place the base with the open side up and the “blade” opening to your right
2. Take "blade" and place it into the base with the wide part near the bottom (closest to you and has the opening for the switch)
3.  Move the blade so it is sticking out half way
4. Lever in the spring plate, do the far side first and make sure the hooks are facing the rest of the part. The bottom left hand side is hard to get it in but you can gently pull the base apart and apply pressure to the spring plate to get it to snap into place.
5. Push the cat all the way in until it latches and you are good to go!!

Trouble shooting/if it does not work:

1. Make sure your hand is not contacting the spring when pressing the switch up/down and hold it horizontal until it wears in. 
2. Make sure the left/bottom spring hook is not contacting the blade when assembling.