My attempt at a box insert for the D&D version of Horrified. 

I was looking to see if anyone had made a box insert for this game. It just came out so couldn't find anyone who has, so I decided to try it myself. This is my first attempt at modeling anything. It is very basic, nothing special. Used FreeCAD to create these models. 

Remove the cardboard insert that comes with the game. 

The card tray has been created with sleeves in mind. 

For the monster cards I am using sleeves that are 64mm by 89 mm and are 60 microns

For the perk cards I ordered sleeves that are 52mm by 105mm. I had trouble finding ones that were close to the size of the cards so I will have link below. As of posting this I have not received the sleeves yet. I made the pocket for them with those measurements in mind and will update when I receive them and test them to fit. 

(Update)

I just received the sleeves and they fit the cards well. They also fit the card tray I made. 

The photos show how I arranged everything in the box. I put the villagers tray below the hero tray but either one on top should work. 

It might be hard to see from the photos but the frenzy marker is the one next to the d20 pocket and the terror marker is next to the displacer beast pocket. 

I lay the items bag flat between the monster mats and the rule book then put the folded board on top. 

I printed mine at a .2mm layer height with 15% infill. 

No supports needed. 

No rafts

No brim

Link to the sleeves I ordered for the Perk cards.

[https://a.co/d/9wA9Hwi](https://a.co/d/9wA9Hwi)